6 effective tips To clean Rust Stains From Tiles
In every aspect, tile flooring adds to the aesthetic appeal of our homes. However, it is important to maintain them correctly to avoid issues such as fading, corrosion, or even flooring cracking. Rusting appears to be the most prevalent condition among all of these. Rust, which is mostly caused by hard water, makes your flooring look dirty and unkempt. Not only that, but rust can weaken the tiles and cause them to fall apart, resulting in holes. Cleaning up rust may seem like an impossible task but, with a few common kitchen ingredients, the task can be accomplished. However, these only work for surface stains, if the rust is deep, it is better to hire house cleaning experts to tackle the issue.
Toothpaste is a wonderful, mild cleaning agent. While there is a variety of toothpaste available, one prepared with baking soda not only removes dental plaque but also helps to erase scuffs and stains. Apply a small amount of paste immediately to the rust cylinder stain and rub it up with the brush in a circular motion. When you’re through, wash the tiles with a little soap and water.
Lemon is one of the greatest natural cleaners because of its high citric acid content. It can clean burnt vessels and rust stains from floors, at the same time, it can also kill germs because of its antibacterial characteristics. In a bowl, squeeze the lemon juice and add a pinch of salt. About a quarter teaspoon of the juice should be poured over the rust spot. Allow it to sit for 10-minute. After that, clean it with a soft-bristled toothbrush. You’ll notice that the rust stain on the floor starts to fade.
No other household cleanser is as effective as vinegar. Whether it’s a mineral deposit, grease, or rust, vinegar’s acidic nature can eliminate all of these tenacious stains in no time. On the rust stain, pour 2-3 teaspoons of vinegar. Allow it to sit for 3-5 minutes. Wipe down the floor with a clean, soft cloth. Repeat the procedure till the rust spot on the floor is gone.
One of the most effective ways to remove rust stains from floor tiles is to use kerosene. It’s similar to vinegar but stronger. Over the stain, pour two tablespoons of kerosene. Allow it to sit for 10-minutes. Rub the surface with a cotton cloth. Allow it to sit for another 5 minutes before wiping it down with water or a paper towel. Make sure you don’t leave it for longer than 10 minutes since it has a strong odour.
You’ve certainly used WD-40 Multi-Use Product to fix a squeaky hinge or dislodge a stuck windowsill, but it’s also an effective rust remover. If you only have surface rust or a rust stain, simply spray some WD-40 straight on the spot, wait ten minutes, and wipe away with a cloth or an old toothbrush. If the rust is particularly obstinate, you may need to use an abrasive sponge.
Tomatoes, like lemons, have a citrus taste to them. It contains an acid that works wonders when it comes to eliminating accumulated minerals or stains. Cut a tomato into two halves and set it aside. Sprinkle a bit of salt on the rust, then rub it with a tomato slice. Allow the juice to sit for 5-7 minutes. Clean with a gentle cloth when finished.
